Panasonic KX-TDA50 & 50G startup sequence

• The SD Memory Card must be inserted in the SD Memory Card slot of the main board before startup.

• Before touching the System Initialize Switch, discharge static electricity by touching ground or wearing a grounding strap.

• Once you have started the system and if you unplug the system, do NOT perform the following procedures to start the Hybrid IP-PBX again. Otherwise, your programmed data is cleared. To restart the Hybrid IP-PBX, refer to "4.1.4 Using the Reset Button".

• The Hybrid IP-PBX will continue to be powered even if the power switch is turned "OFF".

• The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located near the equipment and is easily accessible.

2. Plug the DC connector of the AC adaptor into DC IN 1.

Note: The AC adaptor supplied with the KX-TDA50 must be connected to DC IN 1. If an AC adaptor is connected only to DC IN 2, the KX-TDA50 will not start. If you need to connect an additional AC adaptor, plug the DC connector of the additional AC adaptor into DC IN 2.

3. Plug the AC cord into the AC adaptor, and then plug the other end into an AC outlet.

4. Turn on the power switch. The RUN indicator will flash.

While the RUN indicator is flashing, slide the System Initialize Switch back to the "NORMAL" position.

Depending on the configuration, initialization takes about 1 min to 3 min. If successfully executed, the RUN indicator will stop flashing and stay lit. All data will be cleared, and the KX-TDA50 and all optional service cards (except for the IP-GW4 card) will be initialized to the default values. Display phones should show the time as 01:00. The data of the IP-GW4 card will not be initialized.